In some devices, in order to reach a better seal, will be use the spiral wound gasket. This paper describes the specific steps of the metal spiral wound gasket installation.

　　1. Make sure the steel strip, cores, graphite are in line with the requirements made wound gasket (including specifications, materials, quality) , Then check the crown chakra is in line with the requirements. whether the tailstock position is right, and adjust it.

　　2. After everything is confirmed, the mandrel into the mandrel mold, pull out the spiral wound gasket, pulled out forming the strip through the bolt into the gap, the operating cylinder valve, so that the top round withstood mold core. Operation foot switch, winding three times; then pull out the graphite tape or PTFE tape, spiral wound gasket installation into the wound to the desired size.

　　Finally broke TPFE or graphite,Empty strip winding outside three times to the desired diameter,Cut strips, then boot to go one or two laps,broken graphite or PTFE, air strip wound the outer three times to the desired diameter, cut the steel strip, and then boot to go one or two laps, spiral wound gasket installation, the end of the strip firmly welded to operate the manual valves, return the crown chakra. Shake the right hand wheel, the right mold to leave, and come up with products and win the mold core and weld it to the inner ring to complete the process.

　　3. After Metal spiral wound gasket installation: first confirm whether the items are all of them, and then remove the handwheel handle mounted on the transport, steel strip plate rack, cylinder. place a smooth machine. Turned on the gas source, operating cylinder valve, check the ejector shaft is flexible reciprocating， operating foot switch，so that the operation of the machine，to see whether the abnormal.

　　More about Othello Metal spiral wound gasket,Please contact oth01@othchina.com oth02@othchina.com